Vroom Vroooom! Get your motor running with this wicked Beer mug! Make a statement AND keep someone else from picking up your beer by mistake. Makes a Funtastic gift for all the beer lovers in your life. We used one of our super hefty27.25 oz. Glass Mugs for a bold presentation.
#15-0200 Armour Etch Glass Etching Cream.
#08- 9606 Brushes.
#08- 9415 Masking tape.
Soft paper towels.
Optional:Tweezers, ruler and water soluble marker
1. Wash the item to be etched in hot, soapy dishwater and dry with a soft paper towel then wipe down design area with glass cleaner
2. You may want to mark the center-line of your item before you begin. With a ruler and a water-soluble marker (not a sharpie) draw the centerline on the back side of the item. This makes it easier to create your design in the location you want it on the project
3. Apply any lettering or word stencils first, overlapping the edges where they meet. Avoid touching the sticky side of the stencil as oils from your hands can interfere with adhesion. Using a tweezer to hold stencil while deciding on placement location can help with this.
In this case, the words IS and MY are placed inside the banner from the Mr Mrs sheet. They need to be etched together after the words Beer and Biofuel have been etched and the glass cleaned off. Tweezers are helpful with this. Press them down gently but firmly with a clean gloved finger. Refer to the image.
4. Using a popsicle stick or other dull instrument, press the stencil down gently to prevent the cream from getting underneath during etching.
5. Cover all the glass around the stencils with masking tape, overlapping all edges. Check for exposed spaces by turning the project over and holding up to the light.
Cover enough area so that none of the rinse water will touch any of the other glass while rinsing as even the small amount of etching cream in the water will permanently haze the glass.
6. Put on the rubber gloves. Load the brush with Armour Glass Etching cream. PAT the etch cream onto the stencils (do not brush it on). Apply a thick enough layer of cream to the exposed design area that you can no longer see through it. (View the directions HERE)
7. Leave cream on for 5 minutes
8. Completely rinse off the etch cream under gently flowing temped water. Remove the stencils and masking tape and rinse again. Pat the stencils dry and return to the carrier sheet.
9. Wipe design area with glass cleaner. You may want to redraw centerline on the back of the project again. Arrange all other design elements into their desired location. You can use parts of a stencil design by covering over the unwanted design features with masking tape or by trimming the stencil with scissors. If stencils overlap into each other's design, etch them individually, one at a time.
10. Repeat steps 4 through 8 until all desired design elements have been etched onto the glass
Article Posted: 09/17/2019 01:19:36 PM