Materials

• 15-0200 Armour Etch Glass Etching Cream
• 21-1644 Over N Over Stencil-PUMPKIN FACES
• 21-1645 Over N Over Stencil-REVERSE MR MRS
• 21-1669 Over N Over Stencil-FLAMES

Additional Materials

• Soft Paper Towels
• #15-0315 Glass Cleaner
• #08-9606 Brushes
• #08-9999 Gloves
• #08-9415 Masking Tape

Directions

Preparation and Usage Starting Skills

• Over N Over Stencil Usage Instructions
• Armour Etch Usage Instructions

Project Steps

1. Wash the glass in hot, soapy dish water and dry with soft paper towels.
2. Apply the flame stencils around the rim of the glass. Apply the pumpkin stencil below the flames
3. Apply the letters for Happy Halloween around the inner rim of the pumpkin. Add eyes and mouth in the middle between the words (as shown in picture).
4. Cover all the glass around the stencils with masking tape, overlapping all edges. Cover enough area so that none of the rinse water will touch any of the glass not to be etched while rinsing. Cover over the top of the glass too.
5. Put on the rubber gloves. Load the brush with Armour Glass Etching Cream. PAT the etch cream onto the stencils (do not brush it on). Cover each one with a 1/4 inch layer of cream.
6. Leave the cream on for 5 minutes.
7. Hold the glass upside down so no water will go inside the glass while rinsing. Rinse off the etch cream. Remove the stencils and masking tape and rinse again. Pat the stencils dry and return to the carrier sheet. Dry the glass off.