FREE Shipping on Orders of $39.95 or more!
Blank Over n Over Stencil Material 10" x 8"
Blank Over n Over Stencil Material 10" x 8"
Style #:21-1598
Reusable, self-stick Glass Etching Stencils available in a variety of motif sizes and styles.
Each stencil sheet is 10" X 8" overall size.
Mix or match the designs or repeat them on the same project to create one of a kind projects for
home decor, holiday, special occasions or personalized gift giving.
Our Over N Over blank stencil material is now available for creating your own re-usable custom etching stencils.
Use a pen or marker to trace your design onto the sheet, then use a hobby knife to cut and remove the areas of the design you want to have etched.
The blank stencil can be used in most stencil cutting machines. It is NOT laser compatible.
View Over N Over Instructions

- Clean glass with a Glass Cleaner (avoid cleaners that state they are fingerprint resistant) and dry thoroughly. There should be no fingerprints, dirt or dust on the area you are going to etch.
- Gently peel the Over N Over stencil from the carrier sheet and position stencil on the glass. (If stencil does not lift easily from carrier sheet, place stencil under warm running tap water. Dry thoroughly, then continue)
- Press stencil down and smooth firmly to the glass. Use a piece of clean paper to press the stencil. This will keep your fingerprints off the area you wish to etch.
- Cover the entire area around the edges of the stencil with wide masking tape, overlapping the edges of the stencil. There should be NO spaces or gaps. All remaining exposed glass should be covered and protected. Especially the area you are going to expose to the rinse off water in Step 6.
- Apply a THICK layer of Armour Etch glass etching cream over the stencil design area. Stay within the taped area.
- After approx. 5 minutes, wash off the Armour Etch. Use running tap water (not too hot) to rinse off all traces of Armour Etch. It is helpful if you use your brush to help remove Armour Etch cream and clean the glass while the water is running.
- DRY the entire project with paper towel. The stencil will remain for now.
- Remove the tape around the stencil edges and discard
- Remove the Over N Over stencil gently and replace it back on to the plastic carrier sheet to be reused again. It is helpful to use a pin, tweezer or hobby knife to pick up the edge of the stencil.
- Clean your glass thoroughly with a glass cleaner and dry with a clean paper towel.
Part#: 85-2161
$29.95 $19.99 (Save 33%)
Out Of Stock
Part#: 85-2109
$5.99 $3.25 (Save 46%)
14 In Stock