View Larger Image Email This Item to a Friend Fathers Day Project

SUPPLIES:
#30-2283- 3.5 " x 5 " Vertical Beveled Crescent Picture Frame

#20-0141- Rub N Etch Stencil- Antique Transportation (Cut out vehicle of your choice-Antique Car was used for our project)

#20-9601- Rub N Etch Stencil- Michael Upper Case Letters (Cut two letter D, one letter A)

#20-0565-Rub N Etch Stencil-Word’s 2 (Cut out one Happy Father’s Day)

White Small Rhinestones (4 were used in our project)

#61-3329 Rub N Buff Metallic Wax (gold was used in our project)

Tools:
Ruled paper to fit right half of frame
Scissors
Glass Glue or Hot Fix Wand
Rhinestones
Cotton Swab
Soft paper towel or cloth
1/2" wide masking tape
#08-9999 Plastic or rubber gloves .00/pair
Disposable craft brush

Directions:
(NOTE: Instructions for centering and aligning lettering can be found on our website under INFORMATION - Product Manuals & Instructions- Rub N Etch Stencil Instructions)

1-Using project photo as your guide for placement, lay out stencil pieces on glass. Hold in place with a piece of masking tape.
2-Following website instructions, rub down stencils & mask off as described.† Etch with Etch Cream.
(NOTE: When washing off Etch Cream, only allow water to run AWAY from picture frame portion of glass. Avoid getting water where photo will go!)
3-Dry glass & apply Rub N Buff to all etched areas of glass with a cotton swab, using a swirling motion, filling in the etchings.
4- Allow metallic wax to set a few minutes, then remove excess wax with soft paper towel and discard. Using a clean towel, buff etchings until a soft luster appears and any wax stuck where it does not belong is removed. Sometimes you have to repeat this process a second time if wax did not adhere well to the etching the first time. Allow metallic wax to dry at least 1 hour.
5-Glue Rhinestones where desired. We glued one each on the three hubcaps and one on the center of the steering wheel
6-Rub N Buff will dissolve with glass cleaner, so only clean frame with a soft cloth dampened with water.
7-Insert your photo to complete your project.